Created on 12/14/2016
c
2016 Sun Hydraulics Corporation See www.sunhydraulics.com for detailed product information 1 of 3
MODEL
FLHA
Filter
SERIES 3 / CAPACITY: 160 L/min. / CAVITY: T-16A
Sun filter elements are available as Surface Type (Last Chance) and Depth Style elements. The flow path is Port 2
to Port 1 and should not be used in reverse, even with a reverse free flow check valve installed. The elements have
a high collapse pressure and are intended to be used in line with the system. Filter life will depend on initial system
cleanliness and the amount of dirt ingression to the system when operating.
TECHNICAL DATA
Cavity T-16A
Series 3
Capacity 160 L/min.
Maximum Operating Pressure 350 bar
Valve Hex Size 31,8 mm
Valve Installation Torque 203 - 217 Nm
Seal kit - Cartridge Buna: 990016007
Seal kit - Cartridge EPDM: 990016014
Seal kit - Cartridge Polyurethane: 990016002
Seal kit - Cartridge Viton: 990016006
(X)CONTROL
X Not Adjustable
(D)FILTER RATING
D 40 Micron Nominal (Surface type)
A 3 Micron Nominal (Depth type)
B 10 Micron Nominal (Depth type)
C 25 Micron Nominal (Depth type)
(N)SEAL MATERIAL
N Buna-N
E EPDM
V Viton
MATERIAL/COATING
Standard Material/Coating
/AP Stainless Steel, Passivated
/LH Mild Steel, Zinc-Nickel
snhy.com/
FLHA
NOTES
Capacity rating is dependent on the micron rating of the element. Stated flow capacity in the Technical Data table is based on the 40 micron rating. See
performance curves.
See Related Accessories for replacement elements.
Model Code Example: FLHAXDNCONFIGURATION OPTIONS
Created on 12/14/2016
c
2016 Sun Hydraulics Corporation See www.sunhydraulics.com for detailed product information 2 of 3
Z 1 Micron Nominal (Depth type)
TECHNICAL FEATURES
Installation directly above the subplate will protect the entire valve stack from particles.
Differential crush pressure is 3000 psid (210 bar).
The flow path is Port 2 to Port 1 only.
Cartridges configured with EPDM seals are for use in systems with phosphate ester fluids. Exposure to petroleum based fluids, greases and lubricants will damage
the seals.
Surface type element features a 304 stainless steel mesh media. All internal components are 304 stainless steel.
Surface Type elements have a 40 micron nominal rating (63 micron absolute).
Surface Type elements are designed to capture errant particles that may not be trapped in the main system filter or particles resulting from a component failure.
With a correctly assembled system, Surface Type elements will be unnoticed during regular operation, but will provide protection from sudden component failure.
Surface Type (Last Chance) elements have a single layer stainless steel mesh supported by perforated sheet tube.
Depth type elements are available in 1 µm, 3 µm, 10 µm, and 25 µm nominal ranges.
1, 3, 10, and 25 micron elements have a Beta ratio as shown in the Performance Curves tab.
Depth Type elements feature a pleated microglass media with clear zinc coated components.
PERFORMANCE CURVES
Created on 12/14/2016
c
2016 Sun Hydraulics Corporation See www.sunhydraulics.com for detailed product information 3 of 3
